Quick answer: To find your kada size, measure the inner diameter of a bangle that fits you comfortably. To find your ring size, measure the inner diameter of a ring you already wear, or wrap a strip of paper around your finger and measure its length. Share the measurement in millimetres when you order from Shrim Studio.
A kada or ring only feels special when it fits well. You don’t need a jeweller’s tool — a ruler and a few minutes at home are enough.
How to measure your kada size
Method 1: Use a bangle you already own
- Pick a rigid bangle that slides over your hand comfortably.
- Place it on a ruler and measure straight across the inside, from inner edge to inner edge, at the widest point.
- Note the inner diameter in millimetres and share it with us.
Method 2: Measure your hand
- Bring your thumb and little finger together, as if putting on a bangle.
- Wrap a soft measuring tape or strip of paper around the widest part of your hand, over the knuckles.
- Measure the length and send it to us — we’ll help you choose the right fit.
How to measure your ring size
Method 1: Use a ring that fits
Place a ring that fits the intended finger on a ruler and measure the inner diameter in millimetres, edge to edge.
Method 2: The paper strip
- Cut a thin strip of paper and wrap it around the base of your finger.
- Mark where the paper overlaps, making sure it can still slide over your knuckle.
- Lay it flat and measure the length to the mark in millimetres. That is your finger’s circumference.
Tips for the right fit
- Measure at the end of the day, when fingers and hands are slightly larger.
- Avoid measuring when your hands are cold, as fingers shrink.
- Wide rings and kadas feel tighter than slim ones, so allow a little extra room.
- If you’re between sizes, tell us both measurements and we’ll advise.
Ready to choose? Browse our kadas and rings, then send us your size with your order.